WTS Direct Powered Transponder Specification

Dimensions: 19x19x6mm

Weight: 4g

Humidity: max 90% relative

Signal transfer: magnetic induction

Transponder position: horizontal

Max height 15cm Power feed: RX channel or battery

Connection plug: standard servo plug

Operating voltage: 3V-16VDC (reverse polarity protected)

Power consumption: 14mA @ 6V

Display LED: ultra-bright RED

WTS Instruction

The WTS transponder is compatible with all RC systems including RC version 4 decoders with firmware 4.4 or lower.

Operation is purely lap counting and timing using its 7 DIGIT ID number.

The transponder is ready to be used right away simply by connecting to a battery or plugging into a free receiver channel or the BATT socket.

After power on LED will flash fast. WTS power cable is flexible can be easily replaced. Preheat black part of transponder to 80°C and slowly remove PCB from case.

Solder new cable to PCB pads, check polarity. Insert PCB again to the case. Use "hot glue" to close the case.